Farmall Cub

My cousin has a 140 that his Dad (my Uncle) bought new. It's always been in the family and he uses's it for plowing since his Dad passed away about 5 years ago. He told me today it never ran just right but wasn't bad either. Lately it had gotten worse and finally quit running. He did a little work and found that 4 of the pushrods were badly bent. He needs to replace them but hasn't had any luck finding any. Anyone have a good source or even a few to spare from a parts machine?

Thanks
Ron

He did say it was the 4 cyl engine a 122 I believe.

I have a handfull i can send ya Ron. PM me your address.

Dale

PM sent, Thanks Dale

Ron, I may have messed up responding late at night. I have some out of an A block. I also have a parts C i was going to pull some from.

Then I remembered the C has an A block (113?) as they took the C block and put it in my A.

Now if you are not confused, you are better off than i am, 'cause I can't keep it straight.

If someone knows if these will work, I am glad to send them. Otherwise they are going to China and coming back as tin cans.

Dale

There are at least 3 different part numbers on the push rods for the 113/123 engines. The C and Super A parts catalogs list all 3 parts as interchangeable. So you may be able to see some differences between them, but they interchange.

I will send them Ron, if they are the right length, they should work, if not, he can send them to China for me.

Thanks Dale and Jim, we'll either fix his 140 or make tin cans