Page 1 of 1

grease fitting

Posted: Mon Nov 12, 2012 8:55 pm
by billy clay
is there a grease fitting on the clutch release bearing like a cub has inside the hand hole cover?

Re: grease fitting

Posted: Mon Nov 12, 2012 9:19 pm
by Boss Hog
no

Re: grease fitting

Posted: Tue Nov 13, 2012 7:29 pm
by rexxon
There is a grease fitting on mine, you access it through the small hole on the left side of the clutch housing but not through the hand hole cover.

I assume it is the throwout bearing

Re: grease fitting

Posted: Tue Nov 13, 2012 10:38 pm
by midmo
On a 140 it only greases the the input housing shaft where the throw out bearing slides on not the bearings.
Ron
Correct me if I'm wrong.

Re: grease fitting

Posted: Tue Nov 13, 2012 10:41 pm
by Boss Hog
you are correct, the bearing is sealed

Re: grease fitting

Posted: Thu Nov 15, 2012 6:34 am
by rexxon
AAAAAAAHHHHHHHHHHHH, Grasshopper learn.