Farmall 100, 1954 - 1973
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Thu Dec 27, 2012 12:14 am
I recently picked up my grandpa's '77 140 farmall and ALL
It has had a very hard life since his passing.
I'm trying to just get it running right now..... I have the carb off of it as it needs the float height reset as it overflows the gas. Yet it will only run for about 30 seconds( found during tear-down idle screw turned all the way in) ...
I cant find anywhere a spec sheet on this Marvel carb # TSX 864 to set the float and anything else!
Thanks, David C
Thu Dec 27, 2012 12:46 am
Looks good! I hope you get the carb problem straightened out.
Thu Dec 27, 2012 1:27 am
Most of the 140's run a zenith carburetor mine has a 1222? i think ill have to look an see ...but the marvel carbs are the best to run ill see if i can find a sheet for you on it on it cause im not sure how i will keep looking for one
Very Nice 140 by the way funny look rear weights on it
Thu Dec 27, 2012 7:56 am
Great acquisition, David. Even a fast hitch, too!
I'm jealous. Get in contact with Boss Hog, he knows his 140's.
Thu Dec 27, 2012 10:18 am
Thanks I will
Thu Dec 27, 2012 10:54 am
Old carbs can have dirt stuck in the seat and not shut off even though the float is set correctly. You may have a leak at the gasket for the shut off seat and or you may have a leaky float that has liquid in it. I like to look for the cheap and easy causes first. Check the needle too to see if it has no damage.
Thu Dec 27, 2012 11:03 am
David, In looking at two M/S manuals, both say "set floats 1/4" from gasket face to nearest edge of float, keeping edge of float parallel with gasket. Adjust by using bending tool #M-8." If you go to "johnsoldiron.com" and click on "Ford tractors", then click on "M/S TSX carburetor", you'll find a very good set of photos for disassembly and reassembly. They are for a Ford, but the basic components should be the same.
Thu Dec 27, 2012 12:40 pm
thanks a bunch guys
Thu Dec 27, 2012 12:46 pm
What are those weights you have on the rear? Never seen any of those!
Also, what implements did you get with it? Sure would love to see more pictures of the tractor and the implements!!
Thu Dec 27, 2012 1:05 pm
the center disc on the right wheel is actually a cast weight along with the bolted on weight... I think they are original ???
got the usual cultivators, Cole side dresser, f/h plow, disc (havent seen it yet) and a post hole digger, belly mower, and a pull behind bush hog
Thu Dec 27, 2012 3:34 pm
Now that post hole digger is something not usually seen for a Fast Hitch. Pictures of that would be awesome! Nice Tractor~!
Fri Dec 28, 2012 9:17 am
AL Farmall Boy wrote:Now that post hole digger is something not usually seen for a Fast Hitch. Pictures of that would be awesome! Nice Tractor~!
Looking at the post hole digger, I don't think it's a fast hitch version
I'll get some pics of it soon
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.