Page 1 of 1
what do you think
Posted: Sun Nov 27, 2005 4:43 pm
by mrfrost
i just bought a c today
havent done much research
but i think the serial # 7058
the engine is seized up
all there and the tin is great
of course ,,,upstate ny here
so it sure will need paint
my question after all that babling
is a silly one
where do i dump the marvel mystery oil if im going to try to work this back into shape
i appreciate any help
p.s. a little bigger than my cub
nope
Posted: Sun Nov 27, 2005 5:11 pm
by mrfrost
after trying to get smart
i dont think i have the right nuber for the serial number
ill try again later
Posted: Sun Nov 27, 2005 5:15 pm
by Bigdog
Remove the sparkplugs and pour a little Marvel or Kroil or whatever penetrant you like into the cylinders and let them soak for a while.
Posted: Mon Dec 12, 2005 6:14 am
by 'Country' Elliott
Hey MrFrost...CONGRATULATIONS on your "C"! They're a GREAT mid-sized Farmall (between the Cub, "A" "B" and the BIGGER "H").
Lots of us like to use this method of getting an engine un-stuck: You can jack up the right rear wheel slightly off the ground...put tractor in first gear...and gently rock the wheel back and forth to try to unstick the engine. The BEST thing is to TAKE YOUR TIME! Use KROIL very liberally in all the pistons (after removing the plugs). You'll find that it'll "seep" down along the sides of the piston walls and dissolve the crud that's sticking your rings. GIVE IT A TRY...You'll like the results!
Posted: Mon Dec 12, 2005 8:29 am
by George Willer
'Country' Elliott wrote:Lots of us like to use this method of getting an engine un-stuck: You can jack up the right rear wheel slightly off the ground...put tractor in first gear...and gently rock the wheel back and forth to try to unstick the engine.
I agree with Country Elloitt as usual, with one exception... I would use the highest gear. It would be much more effective. I'm sure he mis-typed.
Take your time!
Posted: Thu Dec 15, 2005 5:24 am
by 'Country' Elliott
Hey George...THANKS MY FRIEND...You're RIGHT...THIRD GEAR...NOT FIRST!
(I musta had my SECOND Maker's Mark & Apple Cider when I was workin' on that thought! SORRY for the mislead
).
Posted: Thu Dec 15, 2005 9:10 am
by John *.?-!.* cub owner
If I remember corredtly, (happens occasionally) the C has wet sleeves, so removing a sleeve and piston assembly to reapir or replace should not be too dificult. Alos as was stated earlier, tow it in highest gear (4th on a C) when trying to break it loose.
breakin it
Posted: Sun Jan 29, 2006 11:28 pm
by cityfarmer
1. rock it in 4th gear
2. get the crank start and try pressure with that
3. if that still doesn't work get a pto shaft put the pto in gear and determine which way the motor wants to spin and apply pressure using both the crank start and pto.
4. Pull the head off and apply pressure to the pistons themselves
*REMEMBER GO SLOW, IF SOMETHING SEEMS TOO TIGHT STOP...You cant always stop and think up another idea, but fixing broken parts, espically cast iron isn't really an option.