Switch to full style
Farmall C & Super C Tractors, 1948-1954

Forum rules

Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Post a reply

Rear Axles leaking

Sat May 24, 2008 8:23 am

Hi all,

I have a 1951 Super C. It leaks grease where the rear axles go into the housing on both left & right sides. I see that there are 4 bolts that hold what looks like a seal retainer. For those of you that have had this problem, is there in fact some type of seal here, and I'm guessing it is a pretty simple job to replace them?

Thanks!
KT

Re: Rear Axles leaking

Sat May 24, 2008 4:44 pm

If it's built like the cub and A, you need to press the bearings off the axle, to change the seals. Ed

Re: Rear Axles leaking

Sat May 24, 2008 7:15 pm

Here is the parts breakdown. You can go to: http://www.caseih.com/parts/parts.aspx?navid=123&RL=ENNA and see the parts list. Click on "Click here to begin your search." on the lower left side of the page and then enter "Super C' under model.


001CSIH-40686 (Small).gif


Click the picture to make it bigger.

Re: Rear Axles leaking

Sun May 25, 2008 8:25 am

If the old seal wore into the axle. When i change seals(any type) I don't hit in the new seal to were the old seal was. I keep them a tad shallow so they have a new surface to seal on rather than were its worn from the old seal. I do this on crankseals too, any type of seal were there is a worn spot(ring). You can adjust were the seal rides by installing it in a different position.
Post a reply