Super C and double bottom plow

Fri Aug 07, 2009 9:40 pm

My father has a Super C and double bottom plow that he's never used. He claims that there is a part missing. I'm hoping to hook this up before cold weather and hope someone might have a photo or two showing the setup. Maybe it might help me to ID what he is talking about.

Re: Super C and double bottom plow

Fri Aug 07, 2009 10:19 pm

A little more info, such as molboard or disk plow, fast hitch or standard, etc. would help.

Re: Super C and double bottom plow

Sat Aug 15, 2009 12:17 pm


Not a Super C. However, here are a couple of picks of the mounted plow on my C. I have a few more images that I can post if this is a similar plow but the images don't show what you need. I also have a few close up shots showing mount points. I am not expert on these by any means and the plow was just mounted for transport in these pictures. Should be close enough to help. It did a fine job plowing last spring.


Rear View showing lift

Side View

Rear View

Re: Super C and double bottom plow

Tue Aug 18, 2009 4:23 pm

Thanks for the photos. They may help out. We had to split the tractor Sunday to repair the clutch plate. Hopefully have it back in shape in a few days then I can gat back to normal.


Re: Super C and double bottom plow

Sun May 12, 2013 2:13 pm

I happened on a set of plows like these with the rock-shaft (not sure what the name is). Plows and rock-shaft look to be complete from the few pictures I have managed to find.
If anyone is interested let me know, I will sell it reasonably. I have Cubs, and someone told me about it because of the IH on it.
I'm located near Dayton Ohio.
I can send pictures to anyone interested.


Re: Super C and double bottom plow

Tue Aug 16, 2016 5:20 pm

I know it's been a while since someone replied to this, but I just recently picked up one of these plows for my C!! Unfortunately I'm missing the linkage that connects to the left side (as you sit on the tractor) touch control and I'm missing part of the axle clamps. Would one of y'all that own one of these mind posting closer pics of these areas and dimensions of the touch control linkage?
Thanks, Sean