Switch to full style
Farmall C & Super C Tractors, 1948-1954

Forum rules

Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Post a reply

Farmall C help

Thu Mar 11, 2010 9:43 am

Ok, I am looking for some advice. I found a Farmall C online and the listing states this tractor can run on kerosene or gas. I am not very familar with the kerosene type tractors. Also did the "C" have a kerosene system? I spoke with the owner on the phone and he told me that the tractor was running last year and then just died so they just covered it up with a tarp and there it sits. He also told me that the sheet metal is good and the motor is not stuck. Ok the bad part is, that he is not available till this weekend and I am not, so I have to send a friend to go and look at the tractor. So please any advice on this would be greatly appreciated, like I said I dont know anything about the Kerosene type fuels.

I will have my friend get some pictures of the Farmall and post this weekend.

Re: Farmall C help

Thu Mar 11, 2010 10:24 am

Dual fuel tractors are nice to have, and really generate some interest. They had 2 fuel tnaks, a small one for gasoline to start and warm up , then a bigger oen for kerosene, distillate, etc. Finding C with one is pretty unusual. Most of them have not been run on kerosene in years. they run on gasoline only simply by readjusting the carburetor. C is a good midsized tractor, and if price is reasonable are good tractors. Being a dual fuel, it more than likely has a magneto instead of distributor, and may have bad points or a coil. The C and Super C were both available in dual fuel, so it could be either. serial numbers form enigne and chassis will tell more about it.

Re: Farmall C help

Thu Mar 11, 2010 11:01 am

Thanks, I will try and get the S/N this weekend. And for the price, I am almost to ashamed to admit it but the guy wants 450.00 for it and told me he was considering something lower. I am almost ready to buy it sight unseen.

Re: Farmall C help

Thu Mar 11, 2010 2:37 pm

Hard to go wrong for $450 (or less). Grab it! :D

Re: Farmall C help

Thu Mar 11, 2010 8:18 pm

Can't have anything but fun for $450

Re: Farmall C help

Sat Mar 13, 2010 12:13 am

good sheet metal and turns over freely, def worth more than 450.00
Post a reply