Page 1 of 1

cub implement part? ID

Posted: Tue May 17, 2011 6:15 am
by Kirk-NJ
Cleaning out a friends barn. Is this a cub part? Kind of hard to see. It's sitting on top of an old running gear frame. His uncle had cubs and a super A and a C. Just trying to figure out what is what.
Thanks
Image

Re: cub implement part? ID

Posted: Tue May 17, 2011 6:42 am
by Gator809
I think it's a rear cultivator section off a C or bigger.

Hank

Re: cub implement part? ID

Posted: Tue May 17, 2011 6:52 am
by Bill Hudson
Also has the jockey arch.

Bill

Re: cub implement part? ID

Posted: Tue May 17, 2011 7:11 am
by v w
Yeah. C, H and M. The U shape in the shaft was to clear the PTO shield. The short tubes are for the lift arms that run forward to the lift cylinders which were on the sides of the engine. As memory best serves me but it has been over 50 years since I mounted one. Vern

Re: cub implement part? ID

Posted: Tue May 17, 2011 8:03 am
by mikethefixitman1
I'm thinkin bigger. At least a C or H or even an M.They may have all been the same.But thats defineatly a rear culitavtor section and I do remember that rear loop.

Re: cub implement part? ID

Posted: Tue May 17, 2011 8:28 am
by CapeCodCubs
Jockey arch was the give away to it being a rear cultivator section...what it is for????

Re: cub implement part? ID

Posted: Tue May 17, 2011 8:33 am
by danovercash
My vote, Super C. We had one like that on Granddads farm.

Re: cub implement part? ID

Posted: Tue May 17, 2011 9:37 am
by Boss Hog
That is off a C or SC
Boss

Re: cub implement part? ID

Posted: Tue May 17, 2011 11:23 pm
by KETCHAM
My H cults for the rear are bigger,,,,I'm going with David on this.C all the way!!!! Kevin :shock: :shock:

Re: cub implement part? ID

Posted: Wed May 18, 2011 6:00 am
by Kirk-NJ
Thank for the replies. I didn't see anything in the cub manual section that came close.

Re: cub implement part? ID

Posted: Wed May 18, 2011 7:21 am
by Boss Hog
KETCHAM wrote:My H cults for the rear are bigger,,,,I'm going with David on this.C all the way!!!! Kevin :shock: :shock:


No speculation on my part, just stating a fact :D

Re: cub implement part? ID

Posted: Wed May 18, 2011 1:58 pm
by Dusty B
Agee w/the C - and they are a b****** to mount because they clamp around the rear axle!! Don't ask me how I know! Dusty B