help with making a new wire harness

Sun Jun 01, 2008 10:15 am

When I looked over the tractor after looking over the battery I noticed the wires have been spliced and the wires are starting to crack on the outside. I am just thinking I need to take out all the wireing and redo it right away. I know from car restores electrical can give you a lot problems that are hard to find. I have not been able to find a place that sells these and with how little wires there are I am thinking I just need to go out make my own.

What I have is three questions. If I stay 6V what gauage wire do I need to run? 2nd where is the best place to by end connections (not sure if they are hardware store buyable)? 3rd what service manual for a Internationl 240 would help me if I get stuck?

I also need all new gauges except for tac since most of them are not working right now.

Thanks for all your help.

Re: help with making a new wire harness

Sun Jun 01, 2008 4:24 pm

Save yourself a lot of headaches and buy a new one from TM or Case/IH.

Re: help with making a new wire harness

Sun Jun 01, 2008 4:30 pm

For a new 240 harness, call Kenneth Updike, at Carter & Gruenewald, 608.455.2411

Re: help with making a new wire harness

Sun Jun 01, 2008 5:16 pm

Thanks Don I missed the 240 part.