This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link:
Privacy Policy

NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.

Hydraulic problems on a 460 D

All other non-specific model Farmall / IH / CASE tractors. (Catch-All)
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
User avatar
Boss Hog
Cub Pro
Cub Pro
Posts: 10290
Joined: Mon Oct 24, 2005 8:35 pm
Zip Code: 23962
eBay ID: dmb2613
Circle of Safety: Y
Location: VA. Randolph

Hydraulic problems on a 460 D

Postby Boss Hog » Mon Oct 06, 2008 6:50 pm

I have some thing sticking a valve most likely But I dont no which one. When you are moving the cylinder at the rear for the lift the engine speeds up or runs free when the cylinder stops the engine bogs down a bit. This should be just the opposite .
Anyone have any Ideas
David
IN GOD WE TRUST
All others pay cash
Boss Hog
Power corrupts; absolute power corrupts absolutely byJohn Emerich Edward Dalberg

SPONSOR AD

Sponsor



Sponsor
 

Jim Becker
Team Cub
Team Cub
Posts: 17241
Joined: Sun Feb 02, 2003 2:59 pm
Zip Code: 55319
Circle of Safety: Y
Location: MN

Re: Hydraulic problems on a 460 D

Postby Jim Becker » Mon Oct 06, 2008 7:05 pm

Are you talking about when the cylinder stops at the limit of travel or at any intermediate position? If only at the end, you probably have a linkage adjustment problem. If at intermediate points, your pressure control valve is probably the problem.

User avatar
Boss Hog
Cub Pro
Cub Pro
Posts: 10290
Joined: Mon Oct 24, 2005 8:35 pm
Zip Code: 23962
eBay ID: dmb2613
Circle of Safety: Y
Location: VA. Randolph

Re: Hydraulic problems on a 460 D

Postby Boss Hog » Mon Oct 06, 2008 7:47 pm

Jim, thanks for the fast response It is doing it all the time no matter where the cylinder is at. The fluid is getting extremly hot
The floor pan burned my foot it got so hot. I can't here very well and am sure the pump is dead heading. At lest my brother says it it making a noise when the lift is not in motion The engine does die down a bit when the cylinder is not moving. and speeds up when the cylinder is moving. Where is the pressure control vale located at.
Thanks
David
IN GOD WE TRUST
All others pay cash
Boss Hog
Power corrupts; absolute power corrupts absolutely byJohn Emerich Edward Dalberg

smigelski
10+ Years
10+ Years
Posts: 872
Joined: Mon Dec 10, 2007 8:46 pm
Zip Code: 08070
Tractors Owned: JD 4040
JD 301A
Ford 3910
Oliver 770
FCub 1947
Fcub 1952
Farmall 100
Location: NJ, pennsville

Re: Hydraulic problems on a 460 D

Postby smigelski » Mon Oct 06, 2008 8:13 pm

question, is there any water in the hydraulic fluid?

Paul_NJ
10+ Years
10+ Years
Posts: 565
Joined: Mon Apr 07, 2003 11:35 am
Location: Morristown, New Jersey

Re: Hydraulic problems on a 460 D

Postby Paul_NJ » Mon Oct 06, 2008 8:14 pm

Best resource you'll ever find is this article:

http://www.oldoakfarmalls.com/Hydraulics%2060%20Series.htm
51 Cub; IH 340 Utility; IH 240 Utility http://public.fotki.com/PWS/

User avatar
Boss Hog
Cub Pro
Cub Pro
Posts: 10290
Joined: Mon Oct 24, 2005 8:35 pm
Zip Code: 23962
eBay ID: dmb2613
Circle of Safety: Y
Location: VA. Randolph

Re: Hydraulic problems on a 460 D

Postby Boss Hog » Mon Oct 06, 2008 9:49 pm

Paul Thanks a thousand times that is a great sight I do believe I will be able to get this thank fixed
David :{_}: :{_}: :{_}: :{_}: :{_}: :{_}:
IN GOD WE TRUST
All others pay cash
Boss Hog
Power corrupts; absolute power corrupts absolutely byJohn Emerich Edward Dalberg

Paul_NJ
10+ Years
10+ Years
Posts: 565
Joined: Mon Apr 07, 2003 11:35 am
Location: Morristown, New Jersey

Re: Hydraulic problems on a 460 D

Postby Paul_NJ » Mon Oct 06, 2008 11:00 pm

David

Here is the valve manifold from my 340U. The valve block on the far left is the pressure control valve, next one is the TeleDepth valve to the rear hitch, and the two on the right are the external hydraulic control valves. Your's may look a little different, but the units are the same.

Image

If you decide to go into the pressure control valve, look for the Blue Ribbon Manual GSS-1278, Valves and Systems. The I&T manual has similar info.
51 Cub; IH 340 Utility; IH 240 Utility http://public.fotki.com/PWS/

Paul_NJ
10+ Years
10+ Years
Posts: 565
Joined: Mon Apr 07, 2003 11:35 am
Location: Morristown, New Jersey

Re: Hydraulic problems on a 460 D

Postby Paul_NJ » Mon Oct 06, 2008 11:13 pm

Let's try that again:

Copy of IMGP0018.JPG


Also, you can usually find that Blue Ribbon Hydraulics Manual on eBay.
51 Cub; IH 340 Utility; IH 240 Utility http://public.fotki.com/PWS/

User avatar
Boss Hog
Cub Pro
Cub Pro
Posts: 10290
Joined: Mon Oct 24, 2005 8:35 pm
Zip Code: 23962
eBay ID: dmb2613
Circle of Safety: Y
Location: VA. Randolph

Re: Hydraulic problems on a 460 D

Postby Boss Hog » Tue Oct 07, 2008 6:20 pm

I pulled the valve off today. I think I have found the problem
Image
Image
It is right dirty, I am going to order the parts tomorrow
Thanks Again for the help
David
IN GOD WE TRUST
All others pay cash
Boss Hog
Power corrupts; absolute power corrupts absolutely byJohn Emerich Edward Dalberg

User avatar
Don McCombs
Team Cub Mentor
Team Cub Mentor
Posts: 17445
Joined: Mon Feb 03, 2003 6:45 am
Zip Code: 21550
Tractors Owned: "1950 Something" Farmall Cub
1957 Farmall Cub w/FH
1977 International Cub w/FH
1978 International Cub
1948 Farmall Super A
Circle of Safety: Y
Location: MD, Deep Creek Lake

Re: Hydraulic problems on a 460 D

Postby Don McCombs » Tue Oct 07, 2008 6:23 pm

I see the problem, too. Your camera is out of focus. :D
Don McCombs
MD, Deep Creek Lake

Image
Proud Member of Maryland Chapter 39

The best teachers are those who show you where to look, but don't tell you what to see.
A. K. Trenfor

User avatar
Bigdog
Team Cub Mentor
Team Cub Mentor
Posts: 24144
Joined: Sun Feb 02, 2003 12:50 pm
Zip Code: 43113
Circle of Safety: Y
Location: OH, Circleville
Contact:

Re: Hydraulic problems on a 460 D

Postby Bigdog » Tue Oct 07, 2008 7:12 pm

The camera is in focus - his valve is out of focus! :lol: :lol: :lol: :lol:
Bigdog
If you can't fix it with a hammer, you've got an electrical problem.

My wife says I don't listen to her. - - - - - - - - Or something like that!

Image

http://www.cubtug.com

User avatar
Boss Hog
Cub Pro
Cub Pro
Posts: 10290
Joined: Mon Oct 24, 2005 8:35 pm
Zip Code: 23962
eBay ID: dmb2613
Circle of Safety: Y
Location: VA. Randolph

Re: Hydraulic problems on a 460 D

Postby Boss Hog » Tue Oct 07, 2008 7:25 pm

Don McCombs wrote:I see the problem, too. Your camera is out of focus. :D


Don, I was shaking like a dog passing persimmon seeds I couldnt get the camera to catch up with the strainer :D
My helper had done run off hard for me to keep a camera steady
IN GOD WE TRUST
All others pay cash
Boss Hog
Power corrupts; absolute power corrupts absolutely byJohn Emerich Edward Dalberg

Paul_NJ
10+ Years
10+ Years
Posts: 565
Joined: Mon Apr 07, 2003 11:35 am
Location: Morristown, New Jersey

Re: Hydraulic problems on a 460 D

Postby Paul_NJ » Tue Oct 07, 2008 10:05 pm

David

Glad you discovered that crushed screen. Mine looked much the same. More than likely the orifice in the plug base is also clogged or restricted. If that is plugged, the regulator can't drop pressure and the safety valve opens instead.

Sit down before they tell you the price . . . it's about $50. I'd advise changing all the o-rings while you're in there, and flush the passageways to ensure no additional crud and contamination is lodged somewhere.

Paul
51 Cub; IH 340 Utility; IH 240 Utility http://public.fotki.com/PWS/


Return to “Farmall / IH / CASE”

Who is online

Users browsing this forum: No registered users and 2 guests