Farmall Cub

When I purchased my Cub I received about 2 1/2 gallons of mower parts. Mostly wear plates, clips, rivits and two guards. Most parts appear to be unused. Some parts have the IH stamp and part number. IH stamped and non-IH stamped parts appear to be identical.

Clip: 5(?)11759R. Not sure about the 5.
Guard: 457676-R21

Those parts fit a bunch of different IH sickle bar mowers, including the Cub mowers. This is all subject to what specific cutter bar choices are on the individual mower. Those are probably pretty common ones. Your specific part numbers seem to be fairly late issue (in my CBI-3 but not CBI-2).

I think your clips are 611759R1, which replaced MB812. Appears to be the high arch that goes at the inner end but not sure. Should be obvious from a close look at the parts.

457676-R21 is a pretty standard guard with a serrated ledger plate. Looks like it replaced MB2041. I looked on Messick's and found 457676R21 replaced by MC2041Z. Seems odd, an R number replaced with an M number. I had been looking at those numbers because my L-22 has MB2041 guards and I should get some replacements to keep from inadvertently parting out another mower.

Your other parts probably fit the same mowers, whether equipped with the same or most other guards.

Thanks Jim.