Sun Feb 22, 2009 8:13 pm
I have a pair of 14,9x24 AG tires i want to mount. The tires say to use 13" wide rims. Right now i have 10" rims so can i get by with these? The 12" wide 4 loop rims were on back order.
Fabricating the 4 loop 12" rims from parts were just out of site price wise. I could save the 10" rims for 11.9 tires and buy the 12" rims and wait.
Mon Feb 23, 2009 8:59 am
I got those same tires. I put them on 15" wide rims. And they are way too wide. The side wall stick out past the rib and make it easier to rip the sidewall out on a obstruction. I think the 12's would be best. But if you didn't mind the work you could try it on a 10" there is a lot of side wall. But I think it would make it look a little pinched. Ps be carefull putting the the tire on the rim. I almost broke my wrist as I was putting the last bead on. I had my hand between the rim and tire when it dropped on and it took three trys to get twisted around to where I could lift the tire off of my arm with my other hand
Fri Feb 27, 2009 4:07 pm
I think i'll get the 12" rims. The side walls do seen to be tougher than the tires i'm used to working on. These are big sneakers that are going on my int154 cub with the front end loader and backhoe.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.