draw bars

Tue Mar 17, 2009 11:36 am

Will someone tell me if a cub and SA drawbar is the same width, I have 5 or 6 and was going to sell some but want to make sure what they are, I throught they was SA but some are about 5/8 thick and some 3/4. Thanks

Re: draw bars

Tue Mar 17, 2009 2:24 pm

I think the width is pretty close to the same. The side brackets are a lot different. I think the hole/slot spacing at the final drive housings is bigger on the Super A. Also, the Super A has 4 holes for height adjustment while the Cub has 3.

Re: draw bars

Tue Mar 17, 2009 3:58 pm

Ok what about some is made out of 5/8 and some 3/4 thick would that be different years or just a heavy duty.

Re: draw bars

Tue Mar 17, 2009 4:20 pm

Drawbar part number never changed and no alternate versions for either the Cub or 140. Since you have a half dozen examples, sort them out by by tractor model then measure each and report back what you find.

Re: draw bars

Wed Mar 18, 2009 10:06 am

The early A draw bar was different from the SA The cub is quit a bit lighter than the SA

Re: draw bars

Wed Mar 18, 2009 9:49 pm

I have pictures, I'll see if I can get them on here.