All other non-specific model Farmall / IH / CASE tractors. (Catch-All)
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Thu Jun 04, 2009 9:34 pm
Bigdog wrote:Sounds like the generator is OK.
It also illustrates why it is a bad idea to disconnect the battery while the engine is running.
Thu Jun 04, 2009 10:33 pm
shouldn't it read 7-8 volts with the feild un-hooked?
Fri Jun 05, 2009 6:30 am
With the field un-grounded there is no reference point for output voltage. There will be no output. The voltage regulator controls the grounding of the field. It appears your generator is functioning correctly - look at your regulator.
Fri Jun 05, 2009 9:21 am
All the following statements are just my beliefs, not absolute facts. That Chrysler generator is not Delco. It will not work properly with a Delco regulator. It may be an Autolite generator. I suggest using a regulator for the specific generator.
Sat Jun 06, 2009 7:02 am
Trying to get to a couple of shows today. If time permits< I will swing by my shop and look for info about the Chrysler generator. Any idea of the year car for which it was original?
Sat Jun 06, 2009 4:28 pm
My literature indicates that Chrysler did use AutoLite for the years 1946-1956, probably other earlier and later years also. If your generator has a number tag, if it starts GHM or GJC, it is a 12 volt unit. But in any event, the Delco regulator will not work.
Mon Jun 29, 2009 10:32 pm
it starts with ggw and from one website I found it is a 6volt unit and the regulator I hooked up would work if I took the cover off it. then it quite but then I had pulled it from my 100 because it didn't work there either.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.