Page 1 of 1
H4 magneto question
Posted: Sat Aug 15, 2009 8:52 pm
by Tractorboy3
Hi there, \
I have a broken housing on an H4 magneto. I have another housing to use, but I cannot get the impulse coupler off. I tried to fabricate a puller out of a 9/16, 18 TPI bolt. But the thread inside the coupler must be 19 or 20 ?? TPI. An unusual size. Does anyone know were I could purchase a puller to get this thing off??
Thanks so much for any help...Tom
Re: H4 magneto question
Posted: Sat Aug 15, 2009 8:55 pm
by RaymondDurban
John *.?-!.* cub owner, a member here on the forum has a friend that makes them. I'm sure he'll be along shortly with the info.
Re: H4 magneto question
Posted: Sat Aug 15, 2009 9:12 pm
by RaymondDurban
Tom, just found out that the fella that made them sold out. PM me your address and I'll send you mine to use.
Re: H4 magneto question
Posted: Sat Aug 15, 2009 9:15 pm
by John *.?-!.* cub owner
The man that made them for me, will only make them If I can get an order for several. So it will be a while. I believe WK was thinking about getting some made, but not sure.
Re: H4 magneto question
Posted: Sat Aug 15, 2009 9:19 pm
by Tractorboy3
Thanks so much....Put me down for a standing order for one..
Re: H4 magneto question
Posted: Sat Aug 15, 2009 9:20 pm
by Tractorboy3
Screwstick wrote:Tom, just found out that the fella that made them sold out. PM me your address and I'll send you mine to use.
Thank you so much...PM sent....Tom
Re: H4 magneto question
Posted: Sat Aug 15, 2009 10:45 pm
by WKPoor
Earl has at least a dozen made and ready to go. 740-969-2927 25.00 to include shipping
Re: H4 magneto question
Posted: Sat Aug 15, 2009 11:12 pm
by Tractorboy3
WKPoor wrote:Earl has at least a dozen made and ready to go. 740-969-2927 25.00 to include shipping
Thanks...going to call tomorrow
Re: H4 magneto question
Posted: Thu Aug 20, 2009 8:55 pm
by Tractorboy3
Wow..got the puller today. Professional quality, A1 Craftsmanship, Grade 8 bolt. If you were on the fence about ordering one of these from Earl, don"t hesitate. This tool is well worth $25. Thank you ...Tom
Re: H4 magneto question
Posted: Thu Aug 20, 2009 8:59 pm
by RaymondDurban
Tom, I was just about to send you a message to see if everything worked out with Earl, and looks like it did. The puller makes a world of difference when working on the Mag. Makes a hard job easy! Glad it worked out.
Re: H4 magneto question
Posted: Thu Aug 20, 2009 9:44 pm
by Tractorboy3
Screwstick wrote:Tom, I was just about to send you a message to see if everything worked out with Earl, and looks like it did. The puller makes a world of difference when working on the Mag. Makes a hard job easy! Glad it worked out.
Thanks Ray...Tom