In the course of refurbishing, the original magneto drive gear was removed and cleaned. The exposed gear has a double "II" mark on it, but I cannot find a corresponding mark of any kind on the idler gear. I read in the I&T repair manual that the magneto drive to idler gear "need not be timed to the engine."
Are any of you familiar with this issue?
If I put #1 cylinder at TDC and set the mag tower to #1, wouldn't that work?
Thanks.
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Farmall H Mag Drive Timing
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
- Stanton
- Cub Pro
- Posts: 7760
- Joined: Mon Jun 22, 2009 6:56 am
- Zip Code: 64070
- Tractors Owned: 1942 Farmall AV, serial #87025
1947 Farmall Circle Cub, serial #2116
1948 Farmall Cub, serial #46066 - Circle of Safety: Y
- Location: Lone Jack, MO
-
- Team Cub Mentor
- Posts: 20372
- Joined: Fri Jul 02, 2004 9:52 pm
- Zip Code: 65051
- Circle of Safety: Y
- Location: Mo. Linn
Re: Farmall H Mag Drive Timing
Yes. Fine tune the rotor location. Magneto fires when points just open. Static time the magneto. Then double check the rotor location, You might have to adjust the rotor location by a tooth or two.
I have an excuse. CRS.
Return to “Farmall H, HV, Super H, 300 & 350”
Who is online
Users browsing this forum: No registered users and 4 guests