Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
can i remove the side rail if i shore up the bell housing and the front bolstercan i rempve the rail . i need to remove it so i can clean the side of the block and oil pan and get some primer and paint in there , of course i was thinkin of doin them 1 at a time un less there is an easy way to do both at the same time 1 would probably be easier for me though , since i am only using rattle can paint . thanx for any help
1955 intrnational lo-boy w/ fasthitch, 1960 farmall cub w/fathitch .fasthitch moleboard ,disk,carryall rotovator,54a blade,I.H. 1ooo loader , Syms all wheather cab. PROUD MEMBER OF THE 500 CLUB LO-BOY THAT IS . 1972 154 lo boy
You can take off one at a time for paint reasons. I would first support the tractor under the bell housing and lift the front wheel till it barely touches the ground. If you do take off both sides be advised that your hood may need to be refitted to the grill by adjusting the radiator base and top hose connection.
Since you are cleaning for a repaint (unless this is detail for retail) it would be good to go ahead and remove front bolster as it will be caked also and they are all but impossible to clean without turning over. Rattle can paint is the same paint as in the can if you using IH 2150 so don't sell the job short just because of the application method.
1955 intrnational lo-boy w/ fasthitch, 1960 farmall cub w/fathitch .fasthitch moleboard ,disk,carryall rotovator,54a blade,I.H. 1ooo loader , Syms all wheather cab. PROUD MEMBER OF THE 500 CLUB LO-BOY THAT IS . 1972 154 lo boy
Tractors Owned: 1947 in well used condition 1948 restored 1948 1949 for sale Nice original 1950 just out of the Demo Range 628 2 wheel Trailer 1950 Demo