Tue Dec 04, 2007 2:01 pm
anyone know what the torque is for the rod bearings on an H motor ?
Tue Dec 04, 2007 4:30 pm
Service Manual calls for 55 ft lb on an M. I doubt if there would be much difference. Book does say the bolts are 7/16.
Tue Dec 04, 2007 4:40 pm
According to the I&T manual, connecting rod bolt torque for an H should be 40 ft. lbs. Main bearing bolts should be torqued to 75 ft. lbs.
Tue Dec 04, 2007 10:04 pm
Tue Dec 04, 2007 11:16 pm
Goodandtight!!! Did you wire your mains like you should????
Wed Dec 05, 2007 5:23 pm
yes, they are wired
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.