Farmall H, HV & Super H, 1939-1954
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Fri Oct 31, 2008 8:38 am
Anyone know how to remove the countershaft nut (which is the drive for the hydraulic pump) on an H?
is it right hand thread? is there a special tool that mimics the pump drive?
Fri Oct 31, 2008 9:08 am
I think it is a right hand thread. Use a pinch bar (not a round one, obviously).
Fri Oct 31, 2008 3:10 pm
thanks, Jim. the service manual simply says "remove nut..." but its not a nut at all.
a piece of 18" X 4" X 1/2" thick flat stock, a pipe wrench inside on the spacer, and a hammer did the trick.
knowing it was not left hand thread increased my confidence to apply the pressure required to remove it. thanks.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.