Farmall H Fender Extensions
Posted: Fri Feb 12, 2010 2:59 pm
by Rudi
Gord is looking for some measurements for the extension brackets that allow the fenders to be moved outwards from the seat. Trying to figure out what stock to use and lay out the extensions. Any help would be greatly appreciated...
Thankee
Re: Farmall H Fender Extensions
Posted: Sat Feb 13, 2010 10:16 am
by Jeff D. N.E. Wis.
Rudi: The set I have measure as follows: The main plate is 12 .250" X 4" X .375". The hole spacing is .625" in from the corners then spaced 2.750" apart down the sides and .625" from the edge for a total of 10 holes. The hole diameter measures .555". I hope this all makes sense. The set also came with a set of spacers that measure: .850" O.D. X .585 I.D. X 1.125" long.
Re: Farmall H Fender Extensions
Posted: Sat Feb 13, 2010 11:06 am
by Rudi
Jeff:
Thanks, I am sure Gord will appreciate. Hoping to make the set before spring. These measurements should do nicely.
