Page 1 of 1

H mixture issues

Posted: Tue Mar 08, 2011 12:07 am
by Bowen
When setting the mixture on my '47 H, I can put the needle in to get a rough run on the lean side but after 1 1/2 turns out from seated, I can continue to turn out and it won't get too rich. It simply runs until the needle is removed completely. The packing isn't real snug.

It has a carb kit rebuild on it.

Is there a small passage in carb that has been overlooked? Is the loose needle packing affecting it? Are some of these so forgiving that over-rich doesn't change it much?

It sputters alittle at idle but runs smooth when throttled up or with any kind of load on it.

Re: H mixture issues

Posted: Tue Mar 08, 2011 9:37 am
by Eugene
http://www.cleancomputes.com/Cub/Blue%2 ... System.htm

Above IH carburetors with pictures/sketches of internal plumbing/passages.

Edit: Thinking partially blocked passage in the idle system.

Re: H mixture issues

Posted: Wed Mar 09, 2011 9:58 pm
by KETCHAM
Ya fix it??? Good carb kit or cheepie??? Kevin It does matter. :shock: :shock: