Farmall H, HV & Super H, 1939-1954
Thu Jun 09, 2011 7:15 am
Recently aquired a 42 H
fourth gear has 2 broke teeth on counter shaft
have the to sliding gears out need to get the lower countershaft out have it loose bearings out etc , book says to lift right out, with the large gear in place it will not come out of the tranny.
anybody been that far into the tranny , to help
I know the gears are pressed and keyed , appears I will have to pull the front gear, any help would be appreciated
Thu Jun 09, 2011 11:13 am
I will be no help on this Phil.Mine works great at the moment and I hope it stays that way.Much differnt than your M??? Good luck.Kevin
Thu Jun 09, 2011 12:38 pm
I talked to Tina Hines at Hines Equipment in Delta Ohio
She said it does come out as one unit , minus the bearings , it is just takes some patience.
IHC was ahead of the times , the puzzles that will only come apart one way , the horseshoes and chain, 2 bent nail things ,chinese puzzle boxes,etc.
Sat Jun 11, 2011 10:31 pm
Got the counter shaft out, found that the front gear was to far forward had to be tapped back on shaft ,came right out.
as a complete assy
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.