With the addition of a 3 pt kit, can I run a wood chipper off the PTO of my H while it is in neutral? I am new to the H. It is a lovely tractor.
Thanks,
Jim
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Farmall H and PTO Wood Chipper
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- 5+ Years
- Posts: 2
- Joined: Thu Aug 06, 2015 11:42 pm
- Zip Code: 58737
-
- 10+ Years
- Posts: 4945
- Joined: Tue Jun 08, 2004 3:04 pm
- Zip Code: 14559
- Circle of Safety: Y
- Location: Rochester, NY
Re: Farmall H and PTO Wood Chipper
It should be able to run a small chipper. Make sure the chipper is rated for a standard 540 PTO and <30HP. For sure it will give it a good workout and make 'er snort.
BE CAREFUL climbing on and off the back of the tractor with the PTO running. It might be a good idea to put a step stool up front so you can climb on and off the front when operating the chipper, so as to avoid the possibility of slipping while climbing down the back and getting tangled in the PTO shaft.
BE CAREFUL climbing on and off the back of the tractor with the PTO running. It might be a good idea to put a step stool up front so you can climb on and off the front when operating the chipper, so as to avoid the possibility of slipping while climbing down the back and getting tangled in the PTO shaft.
-
- 5+ Years
- Posts: 2
- Joined: Thu Aug 06, 2015 11:42 pm
- Zip Code: 58737
Re: Farmall H and PTO Wood Chipper
Thanks Matt. Will give 'er a whirl.
-
- 5+ Years
- Posts: 78
- Joined: Mon Jun 22, 2015 3:12 am
- Zip Code: 76633
Re: Farmall H and PTO Wood Chipper
If you can't afford the full "3-point conversion", some mounting brackets can be fab'd of angle iron that can mount it in the same location - it just won't go up and down.
I had an old hammer mill mounted off the back like that.
I had an old hammer mill mounted off the back like that.
Return to “Farmall H, HV, Super H, 300 & 350”
Who is online
Users browsing this forum: No registered users and 4 guests