Farmall H, HV & Super H, 1939-1954
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Tue Aug 30, 2005 10:20 am
hi folks-just need to know if there is any electrical whiz out there that can help-my ammeter started going negativ about 5 amps when the tractor was running-i replaced the generator which i think was original delco or close to it-kept the regulator-polarized as instructrd and ran it-still shows a neg 5 amps-any ideas or fixes out there?-thanks hank
Tue Aug 30, 2005 10:30 am
sounds like the regulator is stuck. Ground the F terminal on the generator and see if it charges then. If it does, either replace the regulator or open it up and look for burned or sticking contacts.
Sat Sep 10, 2005 4:53 pm
hi BD-well i checked the wiring-looks fine-used ohmmeter to look for shorts-found none-regulator has clean points-one set closed -the other open-closed set shows a spark when i open them up-tried that before when running to see if i had a charge-it went more negative-nothing looks burned-what's next-maybe a new regulator?-thanks-hank
Tue Sep 13, 2005 9:07 am
hi BD-i put the meter on at rest-reads 6.05 volts -at 1/2 throttle or so it reads 6.01 volts-that tell you anything?-i was thinking i might need to take the generator and regulator to the shop and have it run up and checked out-possibly a lemon rebuilt??-let me know-i am going to alberta tomorrow for a few days-i'll contact you as soon as i get back-hank
Tue Sep 13, 2005 9:10 am
henry I know this is off topic but you live in one beautiful part of the country in the finger lakes.
Tue Sep 13, 2005 10:03 am
Hank, I believe that is the next step. It wouldn't be the first bad rebuilt unit. Before you do that though, make sure your grounds are good.
Did you try the same test with the field terminal of the generator grounded?
Tue Sep 13, 2005 12:04 pm
Tue Sep 13, 2005 2:54 pm
Did you try grounding the F terminal?
Wed Sep 21, 2005 11:56 am
hi bd-no i didn't-youy mean check voltage running and ground the f terminal?
Wed Sep 21, 2005 5:14 pm
Yes, ground the F terminal on the generator and start it up. Check the voltage at half throttle or higher. If it's charging, it will read 7 volts or higher. This will tell you whether the regulator circuit or the generator circuit is the problem. Once you know that, we can proceed.
Thu Sep 22, 2005 9:36 am
hi john-i printed yor chart but didn't get all the way to the bottom-maybe my printer is off-what does the box below #4 say after generator on the left and replace voltage on the right?-hank
Thu Sep 22, 2005 9:53 am
hi BD-i'll try that f terminal thing this am-and john-when your chart says regulator base does it mean the case of the regulator?-thanks-hank
Thu Sep 22, 2005 10:15 am
hi BD-i grounded the f terminal-started it up-got 5.9 volts at the battery terminals-what next?-hank
Thu Sep 22, 2005 10:51 am
Sounds to me that the generator ain't generatin. What did the voltage read before you started the tractor
Fri Sep 23, 2005 10:48 am
hi-i think the gen may not be working-i'll take it in today to have it checked-my luck with rebuilts has always been lousy-thanks-hank
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.