Points Gap for a B
Posted: Sat May 17, 2008 12:16 am
I have been working on a b for a little while, and I need to know the pionts gap. I set the gap at .020. Is that close? I tried to look it up on the manuals, but had a hard time.
Farmall Cub
The "International" House of Cubs (est. 5/10/1999)
https://www.farmallcub.com/phpBB2/
Points Gap for a B
https://www.farmallcub.com/phpBB2/viewtopic.php?f=177&t=32027
Page 1 of 1
Re: Points Gap for a B
Posted: Sat May 17, 2008 8:02 am
Set the points gap to .013 if you have a magneto and .020 if you have a distributor.
Re: Points Gap for a B
Posted: Sat May 17, 2008 9:45 am
Thanks, that will probibably make a big difference.
Re: Points Gap for a B
Posted: Sat May 17, 2008 11:05 pm
The B is back up and going! 
It through me for a real loop today. I did not realize that the points cover could be put on out of time. After some serious thought I retimed everything, and 2 cranks later it was running.
It through me for a real loop today. I did not realize that the points cover could be put on out of time. After some serious thought I retimed everything, and 2 cranks later it was running.