Farmall B & BN Tractors, 1939-1947
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Sun Mar 29, 2009 12:28 pm
I don't know if this is what it is called but I'll try to describe it.
My brother-in-law has a B that has a lift system the appears to run off the exhaust. He is not sure if all the parts are there. Does anyone have pix of anything like this or know where I can find them. That is If I am talking about the right thing.
I figure if I help him with this I might have a better chance of weaseling him out of...I mean dealing with him on getting that buzz saw/stationary engine he has sitting around collecting rust.
Sun Mar 29, 2009 1:35 pm
Bill - I believe Cub-Bud recently rebuilt an exhaust lift for his B. I think Jim Becker also may have the information you are looking for.
Sun Mar 29, 2009 5:39 pm
I have yet to complete mine....Jim Becker and Phil Lenke (PWL) each have operational exhaust lifts.
Sun Mar 29, 2009 7:54 pm
Thanks John, that shuold be exactly what my bil needs. I am much appreciative. Even more so if he would relinquish ownership of that engine I keep eyeing.
Mon Mar 30, 2009 5:57 am
Will e-mail our pictures
Mon Mar 30, 2009 9:13 am
The parts for the pneumatic lift are in the tractor Parts Catalog. There were 2 variations of the system (related to control handle and linkage), both are in the catalog. John's manual is of the later style.
Mon Mar 30, 2009 9:25 am
Bill here is our on our BN.
Thu Apr 02, 2009 10:38 am
I have a manual but I don't know if it is the older or newer style, I also have some pictures from Red Power a few years back on a nice setup, but not the vertical lift... I'v been wanting to put mine together to maybe use with the JD #5 mower to lift, but haven't had the time to put all the parts together, my exhaust valve needs some work anyways...
Phil, I like the way yours looks, are those nylon "washers" there on the valve/arm?
Thu Apr 02, 2009 10:59 am
Yes they are nylon.
That is the bowl I bought from you a few years back. reconditioned it.
Tue Apr 07, 2009 11:48 am
Phil, how did you get the shaft coming out of the bowl to seal well? or was it just a good fit? I have mine on the tractor, just not really hooked up to anything, and it leaks like crazy around the shaft. I was thinking of just putting some of that 2 part putty type exhaust epoxy in there, then putting it together and moving the shaft, then take it back apart and wait for it to harden, or just braze it up a bit then machine it down...?
Wed Apr 08, 2009 4:58 am
I put a thin piece of fiberglass cloth around there.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.