Farmall M, Super M, 400, 450 & 560 Tractors, 1939-1963
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Wed Aug 17, 2011 7:44 pm
I will soon be swapping out engines in the M that I bought from Dan R. and am seeking advice from those who have done this before.
What is the best way to remove the engine, Remove radiator and pull engine forward or remove front rails ?
Thanks in advance for your suggestions.
Wed Aug 17, 2011 8:01 pm
Like in a cub, the engine is part of the frame, the rails are implement mounts.
Wed Aug 17, 2011 8:14 pm
I wanted to confirm.
Wed Aug 17, 2011 9:46 pm
John *.?-!.* cub owner wrote:Like in a cub, the engine is part of the frame, the rails are implement mounts.
I don't think so. The front bolster attaches to the front of the rails. The detail I can't remember is whether you can pull the engine while leaving the engine rear support in place. The rear support is a flat plate and I think it is sandwiched between the bell housing and the rails.
Sat Aug 20, 2011 9:55 pm
I can remember help dad remove engines from M's in his shop bck in the day. I'm pretty sure we had to remove the entire front bolster to have enough room to get the engine out.
Wed Sep 14, 2011 10:16 am
The frame rails need to be removed. That rear engine plate has to come off with the engine because the flywheel is behind it.
Wed Sep 14, 2011 1:14 pm
yup, the rails need to be removed, as RustyFarmall said. they are through bolted with the mounting plate for the engine
Thu Sep 15, 2011 1:02 pm
We leave the rails on the bolster easier to move around.
Block the engine up forward of the Hydraulic pump , the only thing holding the engine after the rails are off are 2- 1/ 2 -13 bolts and the dowels
The Plate is bolted on to the rear of the engine so you have to go on the backside of the plate towards the rear of the tractor to break it off the clutch tube. I put the 5/8 bolts back in the rail holes , leaving room for the engine to pop free of the clutch HSG , to keep things steady while I break the engine from the clucth hsg. We did not have a chain falls just a tractor with a bucket .
It is still a process.
Pm me with any hang ups be glad to assist in any situation you may have, we recently did our M
and just finished an engne removal on our H
very similar just Bigger
Thu Sep 15, 2011 8:32 pm
Thanks to all for the info, I should be swapping in the next few weeks and Phil I will contact you if help is needed.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.