pics from Farmall engine swap

Mon Jan 09, 2012 7:42 pm

Here are some pics from the recent farmall M engine swap ImageImageImage This method worked very well, the skidloader was a real usefull machine in this operation. I will soon be ready to start the engine.
Berlin

Re: pics from Farmall engine swap

Mon Jan 09, 2012 9:39 pm

Just a tad heavier than working with a cub!

Re: pics from Farmall M engine swap

Tue Jan 10, 2012 9:31 am

That is and under statement. When the front bolster assy. is balanced two men could handle it , however if it were to get away from you it would not be pretty. My skidloader is a Case 1830, 30 hp gas ( with hand controls ) and I can pick up the whole front of the tractor . but the skidloader is just ready to float if you know what I mean. The skidloader is the most useful machine that I own .I have forks and a bucket with teeth. It realy worked well to be able to pick up the bolster/ front end assy. and just back away . As you can see we left the front rails attached, as recommended by a forum member, we did have to loosen the left side rails a bit to clear the governor assy.
Berlin