Ertl is ready for RPRU, special edition Farmall Cub!
- Thread starter John68
- Start date
HAH!!!!!!!!!!!!
I guess I should get moving on my "high detail" Cub 22 sickle mower. I got all the rock guards and the outer shoe cast in pewter. I plan on doing the knife bar and knives out of a single piece of thin brass. With any luck, it shoudl actually "cut."
Thanks for the hint! oh, and here's a hint for you, I haven't ordered a case of them from you..... yet!
:shock: :shock:
I guess I should get moving on my "high detail" Cub 22 sickle mower. I got all the rock guards and the outer shoe cast in pewter. I plan on doing the knife bar and knives out of a single piece of thin brass. With any luck, it shoudl actually "cut."
Thanks for the hint! oh, and here's a hint for you, I haven't ordered a case of them from you..... yet!
:shock: :shock:
podge
Check again. The ones at RPRU were in one end of the box, and not taped to the box. If you look at the adds for RPRU in the magazines it list Dave Daugherty as the point of contact to order the model from Chapter 17, and Dave told me that he had to put all the little decals in the boxes of the ones sold there. I'm not saying you don't have them in yours, but it was my understanding that Chapter 17 had the decals made, but I could be wrong, I have been before.
Check again. The ones at RPRU were in one end of the box, and not taped to the box. If you look at the adds for RPRU in the magazines it list Dave Daugherty as the point of contact to order the model from Chapter 17, and Dave told me that he had to put all the little decals in the boxes of the ones sold there. I'm not saying you don't have them in yours, but it was my understanding that Chapter 17 had the decals made, but I could be wrong, I have been before.