Thu Jul 15, 2010 7:14 pm
Looking to make a PTO Gauge so I can fix/adjust PTOs on CC104 and CC106. Need the dimension of the gauge.
PS: Tried to post picture, but will not allow BMP?
Thu Jul 15, 2010 10:09 pm
Fri Jul 16, 2010 4:48 am
Yes, I have two for the CC106 that are like yours and the one thats on the CC104 is the older one. The two that go to the CC106 are rusty and the plan is to clean thme up and try to get them to work.
Fri Jul 16, 2010 9:01 pm
If the attachment isn't big enough to read, click the picture for a larger view
You do not have the required permissions to view the files attached to this post.
Wed Jul 21, 2010 4:59 am
PM coming your way!
Wed Jul 21, 2010 8:40 pm
Sent a PM back at you
You get a PM too
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.