Cub 105, hydrostat. Is there a drain plug on the transaxle? If not how do you drain the transaxle?
Eugene
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Hydrostat oil change
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- Team Cub Mentor
- Posts: 20377
- Joined: Fri Jul 02, 2004 9:52 pm
- Zip Code: 65051
- Circle of Safety: Y
- Location: Mo. Linn
-
- 10+ Years
- Posts: 156
- Joined: Sun Mar 02, 2003 6:41 pm
- Location: Millersville, PA
If it's like my 127, and I think it is, then you have to pull the tranny back cover and let her flow. One trick is to just loosen the bolts to where you can crack the seal. No other way around it. Be sure to change the filter and replace the fluid with Hy-Tran. You will need a new cover gasket too. Put it on dry, no sealer.
S.H.A.F.T.
S.H.A.F.T.
"Son, you can do it right, or you can do it again."
-
- 10+ Years
- Posts: 2338
- Joined: Sat Apr 10, 2004 6:12 pm
- Zip Code: 40218
- Circle of Safety: Y
- Location: KY, Louisville
Be ready for a flood of about 2 gallons of fluid (14 pints) when you crack that rear cover. It is best to use Case IH Hy-Tran rather than some other brand that says it meets all spec's, because of Hy-Trans ability to absorb water/moisture, and ALL Cub Cadet transaxles will contain water if from nothing more than condensation.
For the filter be sure to use a hydraulic fluid filter and not an oil filter that fits, because the two are not made the same internally, and you will have a hydro failure sooner or later if you use an oil filter.
For the filter be sure to use a hydraulic fluid filter and not an oil filter that fits, because the two are not made the same internally, and you will have a hydro failure sooner or later if you use an oil filter.
-
- Team Cub Mentor
- Posts: 20377
- Joined: Fri Jul 02, 2004 9:52 pm
- Zip Code: 65051
- Circle of Safety: Y
- Location: Mo. Linn
Hydrostat Oil Change
Dumped the oil in the hydrostat and changed the filter. Below 20 degrees for the past several days. Found clumps of ice in the rear end. Have the Cub, with the rear plate off, sitting on it's rear end over a drain pan. Will wait several days until it warms up so that the ice/water will drain out.
- Bermuda Ken
- 10+ Years
- Posts: 682
- Joined: Fri Feb 07, 2003 8:43 am
- Zip Code: 53536
- Tractors Owned: Tractors owned past/present:
Farmall.....F-1206, F-806 sn#501.
Cub Cadet...Original(s), 122, Spirit of 76, 1200, 1250, 1450, 782, 782 Diesel (2), 984, 982, CADET 000 LT Prototype. - Circle of Safety: Y
- Location: Wisconsin.......The Badger State
- Contact:
-
- Team Cub Mentor
- Posts: 20377
- Joined: Fri Jul 02, 2004 9:52 pm
- Zip Code: 65051
- Circle of Safety: Y
- Location: Mo. Linn
Thanks
Ken:
That's a good idea, thanks. I was going to wipe it down, then blow it out with the vacuum cleaner on exhaust to warm things up and remove any remaining moisture.
Eugene
That's a good idea, thanks. I was going to wipe it down, then blow it out with the vacuum cleaner on exhaust to warm things up and remove any remaining moisture.
Eugene
- Bigdog
- Team Cub Mentor
- Posts: 24144
- Joined: Sun Feb 02, 2003 12:50 pm
- Zip Code: 43113
- Circle of Safety: Y
- Location: OH, Circleville
- Contact:
Eugene - unless your vacuum cleaner is different from most I've seen, I would not use the exhaust to dry the inside of any mechanical component. The filtration system on most vacuums will pass enough junk through the system to significantly contaminate the inside of your hydro. Even wiping it out will not remove all the fine grit that will be blown in there. The brake cleaner will clean the existing deposits and displace the water which should solve your problem.
Bigdog
If you can't fix it with a hammer, you've got an electrical problem.
My wife says I don't listen to her. - - - - - - - - Or something like that!
http://www.cubtug.com
If you can't fix it with a hammer, you've got an electrical problem.
My wife says I don't listen to her. - - - - - - - - Or something like that!
http://www.cubtug.com
-
- Team Cub Mentor
- Posts: 20377
- Joined: Fri Jul 02, 2004 9:52 pm
- Zip Code: 65051
- Circle of Safety: Y
- Location: Mo. Linn
Vacuum Cleaner Story
Had just moved into a newly purchased house. Fireplace contained a hugh pile of ashes. I grabbed the shop vac and started cleaning out the ash. In a few minutes things were getting very dark in the room. I turned around from my clean up to find air in the room filled with ash. It took weeks to clean up the mess.
Eugene
Eugene
Who is online
Users browsing this forum: No registered users and 6 guests