Page 1 of 1
Cub vs Cadet Transmission - Have a Question
Posted: Thu Aug 11, 2011 12:27 pm
by AL Farmall Boy
Do the cadet transmissions have a hole where the PTO shift lever goes on a regular Cub tractor? If so, was the hole plugged or just left open? I am needing a plug for the hole in question.
Re: Cub vs Cadet Transmission - Have a Question
Posted: Thu Aug 11, 2011 12:45 pm
by AL Farmall Boy
Just found this on the CASE/IH site under the 154 loboy section. Looks like it is a 11/16 expansion(?) plug. Number 16 in the picture. Where might I pick one of these up? THANKS!
Re: Cub vs Cadet Transmission - Have a Question
Posted: Thu Aug 11, 2011 1:19 pm
by bob in CT
AL Farmall Boy wrote:Just found this on the CASE/IH site under the 154 loboy section. Looks like it is a 11/16 expansion(?) plug. Number 16 in the picture. Where might I pick one of these up? THANKS!
Try NAPA. Same thing as a "freeze" plug in an engine block. TM is on holiday otherwise they probably stock them. Install it with the cup facing out. Give the center a rap with a hammer and punch and it will expand and seal the opening.
Re: Cub vs Cadet Transmission - Have a Question
Posted: Thu Aug 11, 2011 2:43 pm
by Bob McCarty
I have a Cub that had a piece of wooden dowel inserted there to seal it. Seems to work fine.
Bob
Re: Cub vs Cadet Transmission - Have a Question
Posted: Thu Aug 11, 2011 4:24 pm
by AL Farmall Boy
Ok. Thanks for the help!