IHC Cub Cadet Forum -- Questions and answers to all of your Cadet related issues.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Sun Nov 27, 2011 7:05 pm
The mower in question is a Cub Cadet about 2004 model. When the tractor is first brought out for mowing the clutch readily and quickly engages the blades when the switch is activated. After mowing for a time and the unit reaches normal operating temperature, if the tractor is stopped and the clutch is disengaged, when restarted and the clutch re-engaged, the clutch is very slow to engage, takes several seconds for it to start the blades turning. Any ideas where to start this troubleshooting?
Sun Nov 27, 2011 7:50 pm
Could be that your battery is going bad. If you do not have a really good charge, the clutch will not fully engage. The PTO clutch is also the largest drain on the battery and charging system, so, if the PTO clutch is not adjusted appropriately, it will use more power than usual, and cause both premature wear of the clutch, and drain the power from the battery.
Sun Nov 27, 2011 10:58 pm
Check the air gap in the clutch. Also check for oil on the clutch. If no oil give all the air gap adjustment screws 1/4 turn then try the clutch. Be sure to keep them all even.
Mon Nov 28, 2011 12:22 pm
Thanks for the responses. I'll check them out and see if it makes any difference. Stan
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.