Switch to full style
IHC Cub Cadet Forum -- Questions and answers to all of your Cadet related issues.

Forum rules

Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Post a reply

QA-42 auger problem; Problem solved!

Sat Jan 21, 2012 3:55 pm

While clearing the driveway with my QA-42, the auger slid to the right knocking off the drive chain from its sprocket. :( Also, I noticed the auger shaft is about an inch past the face of the right side bearing, and flush with the left side bearing. I searched the internet and the only thing I could determine is the set screws in the bearings loosened up causing the auger shaft to slip. I am not sure if this is right, any help with this problem would be greatly appreciated.

Thanks,
Phil
Last edited by pharmerphil3 on Sun Jan 22, 2012 2:35 pm, edited 1 time in total.

Re: QA-42 auger problem

Sun Jan 22, 2012 2:34 pm

Problem solved; I found that one of the bearing's set screw had backed out causing the auger to shift to the right. I loosened the remaining set screw, recentered the auger, replaced and tightened both set screws and it works perfectly! :D
Post a reply