. I can't seem to stop it from leaking. Does anyone know of any tricks 
or can give some advise . I cleaned the pan and block very well, straightened the oil pan, used IH gasket and didn't overtighten. Is there a specific torque? Thanks!!!154 oil Pan gasket
Moderator: Team Cub
4 posts
• Page 1 of 1
154 oil Pan gasket
by John in Ct » Thu Jan 26, 2006 9:28 pm
I need to replace the oil pan gasket on my 154 Cub Lo-Boy AGAIN . I can't seem to stop it from leaking. Does anyone know of any tricks or can give some advise . I cleaned the pan and block very well, straightened the oil pan, used IH gasket and didn't overtighten. Is there a specific torque? Thanks!!!
. I can't seem to stop it from leaking. Does anyone know of any tricks or can give some advise . I cleaned the pan and block very well, straightened the oil pan, used IH gasket and didn't overtighten. Is there a specific torque? Thanks!!!- John in Ct
- Cub Star
- Posts: 73
- Joined: Wed Apr 27, 2005 5:43 pm
by John *.?-!.* cub owner » Thu Jan 26, 2006 10:56 pm
As a stupid question, are you sure it is the gasket and not the rear main seal? Might try uisng a layer of silicone gasket compontd on eahc side of the gasket .
"The Constitution is not an instrument for the government
to restrain the people, it is an instrument for the people to restrain the
government lest it come to dominate our lives and interests." Patrick Henry
to restrain the people, it is an instrument for the people to restrain the
government lest it come to dominate our lives and interests." Patrick Henry
-
John *.?-!.* cub owner - Team Cub
- Posts: 17893
- Joined: Sun Feb 02, 2003 2:09 pm
- Location: Mo, Potosi
- Zip Code: 63664
- Tractors Owned: 47, 48, 49 cub plus Wagner loader & other attachments. 41 Farmall H.
by John in Ct » Fri Jan 27, 2006 9:50 pm
The rear main seal is just a few years old. My first thought was also the rear main seal but the flywheel is dry and so is the seal retainer.
- John in Ct
- Cub Star
- Posts: 73
- Joined: Wed Apr 27, 2005 5:43 pm
Oilpan gasket
by Jersey_cub » Sat Jan 28, 2006 7:25 pm
John:
I think John*.?-!.* cub owner has a good idea except you should go around the entire gasket before you set the pan on the block.
This has always worked for me when I have had problems with valve cover gaskets or pan gaskets.
I think John*.?-!.* cub owner has a good idea except you should go around the entire gasket before you set the pan on the block.
This has always worked for me when I have had problems with valve cover gaskets or pan gaskets.
-
Jersey_cub - Cub Star
- Posts: 150
- Joined: Sat Jun 19, 2004 10:41 am
- Location: Farmingdale,NJ
- Zip Code: 07727
- Skype Name: Jersey_cub
- Tractors Owned: 1972 154 Low Boy
1952 Farmall Cub The Little Red Binder
4 posts
• Page 1 of 1
Return to LoBoy Series - 154, 184, 185
Who is online
Users browsing this forum: jpcubs and 1 guest
|
|