Page 1 of 1
154 oil Pan gasket
Posted: Thu Jan 26, 2006 9:28 pm
by John in Ct
I need to replace the oil pan gasket on my 154 Cub Lo-Boy AGAIN
. I can't seem to stop it from leaking. Does anyone know of any tricks
or can give some advise
. I cleaned the pan and block very well, straightened the oil pan, used IH gasket and didn't overtighten. Is there a specific torque? Thanks!!!
Posted: Thu Jan 26, 2006 10:56 pm
by John *.?-!.* cub owner
As a stupid question, are you sure it is the gasket and not the rear main seal? Might try uisng a layer of silicone gasket compontd on eahc side of the gasket .
Posted: Fri Jan 27, 2006 9:50 pm
by John in Ct
The rear main seal is just a few years old. My first thought was also the rear main seal but the flywheel is dry and so is the seal retainer.
Oilpan gasket
Posted: Sat Jan 28, 2006 7:25 pm
by Jersey_cub
John:
I think John*.?-!.* cub owner has a good idea except you should go around the entire gasket before you set the pan on the block.
This has always worked for me when I have had problems with valve cover gaskets or pan gaskets.