My PTO on my Int 154 cub??

Fri Oct 12, 2007 9:06 am

Since our splines are the same on the Farmall cub to the Int 154 cub how can i adapt the larger pto spline hydraulic pump to our smaller spline?
I'm thinking of adding a Prince hydraulic pump on my PTO on my 154 to run my FEL. Does someone manufacture a sleeve to do this? :oops:

Or do i need to tap into the PTO input shaft with my pulleys for the added pump?

The smaller 3pt backhoe attachments have the prince pump with the larger spline too. :roll:

Its recomemded that i use a 5 to 8 GPM pump or higher that has 2,500 to 3,000psi to run my FEL and backhoe attachments. Speed and pressure is the key to time vs digging. Plus a good heavy subframe too.

Fri Oct 12, 2007 10:06 am

Bill, there is a sleeve. Probably available from CNH dealers or possibly McMaster Carr.