Page 1 of 1
Part interchangeabilty
Posted: Fri May 23, 2008 11:34 am
by Bob Underwood
Will the the final drives on a Lo-Boy bolt to a regular cub transmission?
Thank you,
Bob
Re: Part interchangeabilty
Posted: Fri May 23, 2008 12:00 pm
by Hengy
Yes and no, Bob. They will directly bolt in position on the tranny, but only in the lowboy position. There are pilot holes on the finals that correspond to the locator pins on the transmission. These are in different positions on the loboy final than the cub. They can't be used on an F-cub that you want to keep as a "high" cub...
Mike in La Crosse, WI
Re: Part interchangeabilty
Posted: Fri May 23, 2008 12:18 pm
by Bob Underwood
Mike;
Just to be clear if I take the Lo-Boy parts loose at the transmission they will bolt to the the cub transmission. I'm trying to help a neighbor so I want to be sure. His transmission is shot
he has located 2 reg cub rear ends, just don"t want to be the one giving bad info.
Thanks
Bob
Re: Part interchangeabilty
Posted: Fri May 23, 2008 1:07 pm
by Hengy
Bob Underwood wrote:Mike;
Just to be clear if I take the Lo-Boy parts loose at the transmission they will bolt to the the cub transmission. I'm trying to help a neighbor so I want to be sure. His transmission is shot
he has located 2 reg cub rear ends, just don"t want to be the one giving bad info.
Thanks
Bob
A cub transmission will work in a loboy and will work in a cub. (my tranny in my Fcub is a loboy tranny with CUB finals) The finals CANNOT be interchanged between a Cub and a loboy.
Hope that helps!
Mike in La Crosse, WI