Mon Jun 22, 2009 7:18 pm
Does anyone have a 154 apart? I need the diameter of the lower radiator hose ends.
Mon Jun 22, 2009 8:00 pm
Larry, if no one answers tonight, I'll get you some numbers tomorrow. One of mine I used a generic hose from Autozone. It was a little big, but clamped up tight.
Tue Jun 23, 2009 12:16 am
These are on ebay time to time. I got some used ones that still looked good.
Tue Jun 23, 2009 4:39 pm
The hose is part # 404550R1.......it measures 1 5/8" ID. I use a # 28 hose clamp to secure this.
The hose is still offered by IH. We stock it at C&G.
Tue Jun 23, 2009 6:36 pm
That is the same number I tried a few days ago on the C&G site. Does not appear to be a valid number.
Tue Jun 23, 2009 8:59 pm
I measured today, as Ken posted the lower manifold is 1 5/8" OD. I used 1 3/4" ID generic hose from Autozone and it tightened up fine with no leaks. I'll take some photos if you need.
Sun Jun 28, 2009 11:24 am
Thanks, I was trying to avoid draining and taking the hose off to measure only to hav to put it together again until I go a hose. No auto store that I went to yesterday had a hose that would fit. I will have to call C&G to order since the part number does not agree with the website.
Fri Jul 03, 2009 9:28 am
Have you tried www.wengers.com
for int154 parts? I been buying some stuff from them too.
Two of my int154's need new clutches. They have new and used parts.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.