Farmall Cub

Does anyone have a 154 apart? I need the diameter of the lower radiator hose ends.
Thanks.

Larry, if no one answers tonight, I'll get you some numbers tomorrow. One of mine I used a generic hose from Autozone. It was a little big, but clamped up tight.

These are on ebay time to time. I got some used ones that still looked good.

The hose is part # 404550R1.......it measures 1 5/8" ID. I use a # 28 hose clamp to secure this.

The hose is still offered by IH. We stock it at C&G.

That is the same number I tried a few days ago on the C&G site. Does not appear to be a valid number.

I measured today, as Ken posted the lower manifold is 1 5/8" OD. I used 1 3/4" ID generic hose from Autozone and it tightened up fine with no leaks. I'll take some photos if you need.

Thanks, I was trying to avoid draining and taking the hose off to measure only to hav to put it together again until I go a hose. No auto store that I went to yesterday had a hose that would fit. I will have to call C&G to order since the part number does not agree with the website.

Have you tried www.wengers.com for int154 parts? I been buying some stuff from them too.

Two of my int154's need new clutches. They have new and used parts.