Rear Light

[bookman51]

Well, While I have the fenders off my tractor I figured I would wire in my rear light. I need the lens (is it a Case-IH item still available) and the bulb, which I assume is standard item. But most importantly, I need to know where to wire the wire from the light to wherever. The has been cut as it comes out of the rear light holder.

Also, I do I wire in the after switch on the clutch. It has been disconnected also...do not know for a reason or not.

Thanks

Bookman

[jsharp1071]

A site sponsor, TM Tractor has them under New Parts, electrical, page 3. Also OEM tractor parts:

http://www.oemtractorparts.com/shop4/pc ... ategory=35

[bookman51]

Thanks I just sent them an e-mail with the part number.

Bookman

[jsharp1071]

I may be mistaken. Didn't notice you were writing about the number series. Hope these suppliers will have what youre looking for. Very sorry.

[outdoors4evr]

There are a couple of rear lights available. The standard is a single (white) light that has a hot lead that runs to the switch through a block. (Get a wiring diagram for your tractor)
The housing is smaller for this one.

The other is a combination rear light. This has a white light that also has a red window through the rear reflector that allows a second taillight bulb to illuminate red. There are three wires that go to this light. Ground, and one for each bulb. You really need a wiring diagram for this one!
The housing is larger to accomodate the second bulb.

[bookman51]

I do have a wiring diagram. Does not exactly tell me everything I need to know (since I am starting from way back). I am getting the combination light lens from Bob and Joe Naylor. They do not have the lense for the other lights.
I will check and see if it is still a Case-IH item or from elsewhere.


Thanks

Bookman