WestDeerPirate wrote:If I am understanding part number #10, which is toothed, there should be a nut or something holding in place along with a washer. I have no idea just guessing. Once I have this arm disconnected I should be able to turn the wheel may be a 1/4 turn and then reattach the steering arm.
Is that pretty close to what everyone else was thinking?
I also have a call into Bob Naylor.
By looking at the vague diagram it appears the arm is held on with a nut, the part (shaft) it goes on appears to be smooth and tapered and threaded at the end and by tightening the nut it compresses the arm (10) onto the shaft. IF that is the case the “bump” may have just turned the arm on the shaft, leaving it in a wrong orientation to the rest of the steering. Again all speculation on my part, but I think this is what others are also saying and you are asking confirmation on.
Good luck,