PTO CLUTCH lever ball bearings???

Sat Aug 14, 2010 5:44 pm

I'm looking for a cross over bearing number for the pto lever bearings the Ih part number is IH-59769-C92 is there any other source than going to IH to get the them??? Can these be interchanged with another bearing?

I also need new seals for my 3260 mower deck the IH part number is #473428-R92 again is there any source or is there another seal that interchanges?

I ordered the bearings and seals but its been since the spring and i haven't got them yet. The first frost will be here by the time i get her running then i'll seafoam her up for the winter.

Re: PTO CLUTCH lever ball bearings???

Sun Aug 15, 2010 4:51 am

I would think a NAPA or other parts place could cross over to a BSA bearing and a National seal without a problem. I've measured them up and found them that way also.

Re: PTO CLUTCH lever ball bearings???

Sun Aug 15, 2010 10:07 am

Ok i'll try my old napa store.

Re: PTO CLUTCH lever ball bearings???

Sun Aug 15, 2010 9:00 pm

Bill, You will have to get the exact same bearing with the snap/retainer rings in the outside race. There are several varients of that bearing and most do not have these rings. I will look tomorrow to see if I have my old ones lying around still. If I do the numbers were on the brgs.

If I remember right the correct ones were not much different pricewise at Napa than Case/IH.

Re: PTO CLUTCH lever ball bearings???

Tue Aug 17, 2010 12:55 pm

Bill I checked around and could not find the old ones but I did find they are a SKF 6007 series.

That makes it 35mm ID x 62mm OD x 14mm W

Looking in my BCA book it looks like a BCA 107FFL (sealed both sides with outer snap ring ) would work.

Here is a link to one

http://cgi.ebay.com/1-FAFNIR-9107PPG-Ba ... 0641242252