Thu May 05, 2011 11:14 pm
Can any one tell me what size belts the mower deck requires? It has one long belt running from the PTO to the center of the deck, and two shorter belts from the center pulley to the outside pulleys. Also, how do you adjust the tension on the two smaller belts?
Fri May 06, 2011 8:00 am
I don't know about the belt sizes, but to adjust tension on the short belts, loosen & slide the idler pulleys.
Fri May 06, 2011 12:47 pm
Thank you for the information regarding adjusting the tension. I wondered if that was how it was done.
Fri May 06, 2011 7:51 pm
I was able to get the belts from Messicks in Elizabethtown, PA. I got them mounted this evening and am ready to mow tomorrow. Hope the rain holds off.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.