Switch to full style
IH CUB LoBoy Series - 154, 184, 185 Forum -- Questions and answers to all of your LoBoy related issues.

Forum rules

Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Post a reply

154 input shaft

Wed Dec 21, 2011 10:28 am

Trying to find the diameter of the trans input shaft, the part that holds the driven disc. I want to build mine back to the correct diameter. Anyone have an unmolested input shaft they can check?

Re: 154 input shaft

Sat Dec 24, 2011 10:04 am

I believe our new input shafts are .865 and the rear flywheel is .875, but a word of caution. Check to be sure your flywheel is correct. Normally the flywheel wears before the shaft. Suggest you drill out the flywheel so it is perfect (if it needs it) and then build up your input shaft to match. They need to be very snug.
Good Luck

Re: 154 input shaft

Wed Jan 04, 2012 9:46 am

THanks, the driven disc was worn and the ear actually cracked while tightened. There was a bubble inside, casting defect, but that was the end of the disc.

Ordered yesterday, used input shaft and driven disc. I did not realize that if we are not happy with the parts the return shipping is paid by you. Wow, can't get better service than that!
Post a reply