IH CUB LoBoy Series - 154, 184, 185 Forum -- Questions and answers to all of your LoBoy related issues.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Tue Sep 11, 2012 8:59 pm
I am working on getting my bar mower installed and working before I lose all the parts. I have it all mounted and pretty much figured out except the rear drive pulley seems to be very tight on the PTO shaft. I will probably have to put it on with a hammer which assures I will need a puller every time I take it off. That does not seem correct to me. So I thought I would ask here and see if anybody else has had this issue. Thanks.-Phil
Wed Sep 12, 2012 7:33 am
What tractor are you putting this on and what model of sicle bar mower are you installing?
Wed Sep 12, 2012 5:14 pm
Am mounting a 22 series mower on a 154 Lowboy have everything mounted still working on the bar height adjustment stuff. Just seems rear PTO pulley will have to be tapped on. May just be tight as I don't think this was ever used much.
Wed Sep 12, 2012 8:41 pm
Be sure to clean the splines on both the pto shaft and the pulley.
Wed Sep 12, 2012 8:49 pm
washbb wrote:Am mounting a 22 series mower on a 154 Lowboy ....
Do you have a model 222 mower, or a L-22? The PTO pulley is the same, but the brackets and design are different.
As Denny said , clean the splines on the PTO and the pulley. If its still tight, you might try to open up the pulley a bit with a small chisel with the bolt loose.
Fri Sep 14, 2012 8:44 pm
Got it on getting ready to try out thanks.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.