IH CUB LoBoy Series - 154, 184, 185 Discussion Forum
Wed Apr 27, 2005 5:52 pm
What is the
correct torque for a 154 Cub Lo-Boy oil pan? Please, don't say snug because I tend to over torque
bolts, lol. Also, how do you get the part of the oil pan that goes against the gasket flat? Thanks!!
Wed Apr 27, 2005 8:24 pm
John. Don't know if there is a specific spec for the oil pan bolt torque, but 5/16-18 oil pan bolts with the lock washers should be approx. 12 - 13 ft lbs.
If your oil pan is distorted from over tightning, you can pound/press it back into shape carefully and check it on a flat surface. I've used wood block and hammer, but be careful! Others with better experience will have to address this for sure...............
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.