Page 1 of 1
Woods 44LB help
Posted: Mon Mar 11, 2013 6:38 pm
by tmays
Idler pulley on my Woods mower separated from the bearing. Solution? Is it a press fit? I can put it back in by hand. Parts do not look damaged
Re: Woods 44LB help
Posted: Mon Mar 11, 2013 6:42 pm
by Former Member
Thomas, what is the diameter of the pulley? Is it off a woods 42"?
Re: Woods 44LB help
Posted: Mon Mar 11, 2013 6:44 pm
by tmays
It's a 44 LB Dale. On my 154 loboy
Re: Woods 44LB help
Posted: Mon Mar 11, 2013 6:51 pm
by Former Member
Hmmm, does Hamilton Bob have any I wonder.
If it presses in by hand, can you stake it in place like a rear main seal
Re: Woods 44LB help
Posted: Mon Mar 11, 2013 8:59 pm
by Eugene
Measure the bearing shaft hole diameter and the bearing od diameter in the pulley. Auto parts store or machine supply store for replacement - press in bearing.
Also check the bearing for part number.