Anything that might not belong on the other message boards!
1. Keep it clean.
2. Keep the discussion civil.
3. Name calling is not allowed.
Politics and religion are two topics that tend to degenerate into a violation of one of the three simple rules above.
The mods and the site admin reserve the right to "lock" or "delete" any discussion that in our opinion, is "heading in the wrong direction."
MOST of all, be respectful of your fellow Cubber's opinions. Don't expect to change someones belief system from a simple forum on the internet.
Mon Oct 22, 2012 8:36 pm
This was one of the items in it. A post mounted hand powered drill press. This is one of the fancier ones I have seen, including a mechanism to automatically advance the drill bit with each turn of the hand crank in adjustable mounts, and a separate foot that can be moved up and down. Most of them are part of the main unit, and fixed in position.
Mon Oct 22, 2012 9:30 pm
I always enjoy the old tools whenever/wherever I get to see them. Ray has Pepere Albert's Press Drill that is easily over 100 years old. They are magnificent pieces.
I hope some of these old pieces will find homes and not the scrap bin.....
Mon Oct 22, 2012 9:33 pm
Rudi, this farm has been in the same family for 3 generations, and Scrivet who bought it is a nephew. All the old tools and anything else reasonable will be saved.
Mon Oct 22, 2012 9:36 pm
I am glad that is going to happen. A legacy farm -- wonderful. Scrivet's will be the best home possible.
Mon Oct 22, 2012 9:44 pm
I probably have some drill bits that may fit the chuck. Measure the chuck diameter and if the drill bit is round with one side flattened off.
Mon Oct 22, 2012 10:07 pm
I have my grandfathers old post drill, it also has the "dog" to advance it as it turns. He put a pulley on it and put a motor on it at some point. I remember he used it quite often. I have a big coffee can full of drill bits for it as well. One day it will be cleaned up and mounted on my shop wall, if nothing else, to bring back memories of grandpa tinkering with it.
Tue Oct 23, 2012 3:24 am
My dad also has one of those David, pretty heavy made as I remember and it's still mounted in the garage. Younger brother and I have cranked that thing enough to go around the world without even having a bit in it.
It always fascinated me watching all that rigging work especially the latch on top that advanced the drill bit. A good hard spin and it would go on and on by itself.
I'll let Grayson give it a whirll the next time we're on the farm.
Tue Oct 23, 2012 8:34 am
Slightly off topic, but here is one I have that belonged to my Great Grandfather. He was a wheel wright, and he and his brother built wagons for people traveling to the California gold rush. The two of them built 50 wagons for the gold rush in one year. which for 2 men to do was quite an accomplishment, because it involved cutting the trees, sawing out the lumber, etc. Below is a picture of their post drill which I have along with some of their old tools. Note how basic this one is, the wheel lowers the bit and the crank on top turns the shaft. No gears, no flywheel, no advance, just the basics.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.