Anything that might not belong on the other message boards!
1. Keep it clean.
2. Keep the discussion civil.
3. Name calling is not allowed.
Politics and religion are two topics that tend to degenerate into a violation of one of the three simple rules above.
The mods and the site admin reserve the right to "lock" or "delete" any discussion that in our opinion, is "heading in the wrong direction."
MOST of all, be respectful of your fellow Cubber's opinions. Don't expect to change someones belief system from a simple forum on the internet.
Sat Nov 24, 2012 7:22 pm
Has anyone used a tail pipe expander from any autoparts stores? I have two pipes that are both 2 3/8" and I want to flare one to go in the other. The pipes are fence corner posts that are 16 guage.
Sat Nov 24, 2012 7:46 pm
i would take it to a muffler shop if you have one close.
Sat Nov 24, 2012 8:25 pm
Yes they work well. In fact, I wound up buying one because I found the chain cutter just as useful to have around as the pipe expanders. I was wasting too much time running up to auto parts to borrow theirs when I needed to fit pipe.
Ran around $75.00 if I remember. The set does have a lifetime warranty, the only catch is you have to ship the broken piece to TX. for exchange, which I did have to do with the large expander. I was probably asking too much of it when one expansion piece snapped.
- 1353806636-picsay.jpg (49.5 KiB) Viewed 566 times
Sun Nov 25, 2012 1:04 am
Take it to a muffler shop with a hydraulic expander. My experience with the manual version is they are good for making the pipe round, not so good at expanding. Hard to hang on to the pipe and you end up making the expansion funnel shaped.
Sun Nov 25, 2012 8:55 am
I have mig welded and gas welded exhaust pipes.
Sun Nov 25, 2012 10:01 am
I was going to make the same suggestion as Scrivet. Your fence post pipe is heavier gauge than most tail pipes, and the manual expander may not work well. The hydraulic rigs that the muffler shops have will handle much heavier pipe. I know you did not ask about this part, but in my area the muffler shops will do an exhaust job including labor cheaper than what I can buy the parts at a parts store.
Sun Nov 25, 2012 10:06 am
Why not get one end crimped so it will go into the other like chain link fence top rail?
Sun Nov 25, 2012 9:36 pm
We had some at work and they were absolutely worthless for expanding. Worked OK for making a bent end round again.
Mon Nov 26, 2012 8:27 am
Take it to a muffler shop it will make it easier on yourself. Just my 2c.
Mon Nov 26, 2012 7:25 pm
I found a local muffler shop , he said he could do it for a couple of bucks. we shall see if it works.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.